Hi A question about combining pre- & post-processor scripts. I don't know much yet about Lua, but when we use a FOR loop in a pre- processor script to invoke a post-processor script, I think these are separate instances of Lua and don't share data. Is that correct?
For instance, assume you move a block incrementally in a pre- processor FOR loop, then find the force on the block in a post- processor script. You can keep track of the block's position in the pre script and print it to file. You can also print the force on the block at the current position while in the post-processor file. However, to create a list of force vs. position as the iteration continues, you have to keep opening & closing the file as you shuttle between the pre- & post-processor scripts, because they don't share variables: is that correct? It seems very messy.
It would be better if the post-processor script could query the position of the block, then write the position and corresponding force at the same time. I can't see how to do this. Looking throught manual.pdf, I can't find a command which queries the current position of a given point. Selectnode doesn't seem to be appropriate (in general) because it is a proximity command (therefore when the block moves away from the reference point, the command will start selecting the wrong node). Secondly, even if a particular node or segment could be selected, it seems you can set its properties but not query them. Is this correct? Is there a better way?
Thanks Ross
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/