[femm] Re: part motor stator modeling???

[Dcm3c@xxxxxxx]

In a message dated 3/23/00 2:22:50 AM Eastern Standard Time, 
pvallian@xxxxxxxxxxxxxxx writes:

> i have just finished modeling a 400kw/6kv induction motor/ complete
> stator. Was it possible to model only a pole?
> If yes, how do you insert the limit conditions (periodic / aperiodic)
> of potential in the borders of the model??

The program currently can't do periodic boundary conditions--you have to 
model the whole machine, unless things are symmetric enough to apply A=0 or 
dA/dn=0 boundary conditions to get the symmetry.

Dave.