I’m sorry…but It didn’t
work. I solved the problem, got the flux lines, but when I try to click on
the center contour line. It is not selected…
What I did wrong?
Juan
-----Mensaje
original-----
De: Dave Squires
[mailto:djsquires@xxxxxxxx]
Enviado el: Miércoles, 19
de Marzo de 2003 14:28
Para: femm@xxxxxxxxxxxxxxx
Asunto: Re: [femm] torque
calculation example
Here is a simple 2-pole motor example.
Juan,
Here is a very simple example.
There are other ways, of course, but maybe
this is good enough?
No special boundary conditions are used.
The mesh is 0.02" between the rotor and
stator
magnets. Units are inches.
Once simulated use FEMMVIEW then left click on
the center contour line between the rotor and
stator magnets going clockwise.
Then click on the integrate->torque
from stress tensor selection.
The gap is large to make it simple and so it
runs fast. I used version 3.2.
I hope this helps.
DRS
penquista66 wrote:
> Hi Femm people
>
> I'm wondering if anyone can send a simple
torque example calculation.
> I'm teaching an electromechanical energy
conversion class and I'll be
> very interested to show to my students the
procedure to calculate
> torque using FEMM with a simple example.
>
> Thanks
>
> Juan A.
>
>
>
>
>
>
> Your use of Yahoo! Groups is subject tohttp://docs.yahoo.com/info/terms/
>
>
>
Your use of Yahoo! Groups is
subject to the Yahoo! Terms of
Service.