[FEMM] error in fkern-FEMM 4

[Ahmad Eid <ahmad_m_eid@xxxxxxxxx>]

Dear all 

I tried to define AC problems with frequency of 50 HZ
for simulating permanent magnet linear motor, but
after creating mesh, there is an error as:

" One-edge lamination not supported in AC analyses"
Then the solution stops.

I separted the coils from the core laminations, but
the same error appears again.

Does anyone know what the reson of this error?
Any suggestion will be appreciated.

Ahmad 


	
		
__________________________________
Do you Yahoo!?
Win a $20,000 Career Makeover at Yahoo! HotJobs  
http://hotjobs.sweepstakes.yahoo.com/careermakeover