Re: Induction Motor in FEMM

["marsupiofr" <marsupio@xxxxxxxxxxx>]

Dave,

really a great great post !!!


--- In femm@xxxx, "David Meeker" <dcm3c@xxxx> wrote:
> Ok--I've been threatening to make an example of how one might go 
about
> analyzing an induction motor using FEMM, and now I've done it.  
Well,
> at least I've got a draft of an example anyhow...
> 
> If you're interested checking out this example, I've put it at:
> http://femm.berlios.de/2horse.zip
> 
> This example goes through the identification of parameters in an
> induction motor model with FEMM. Torque results from the circuit
> model are then compared to torques predicted via stress tensor
> integrations. Some additional issues are also presented that are
> important to consider for the purposes of design and comparison to
> experimental results.
> 
> If I've made a mistake in the example, please point it out to me--I
> don't usually do "normal" induction motors...
> 
> Dave.
> 
> 
> 
> --- In femm@xxxx, Lindolfo Marra <lindolfomcneto@xxxx> wrote:
> > I am work with simulation in the induction motor. Simulation lf
> loked rotor conditions and running conditions.The simulation is not
> good. Femm(groups), you make this simulation, please you can send 
the
> simulation(rotor conditions and running conditions) in the FEMM. 
thank
> you 
> > 
> > ---------------------------------
> > Yahoo! PageBuilder - O super editor para criação de sites: é 
grátis,
> fácil e rápido.