Re: [femm] Call to triangle unsucessful after import of DXF

["Eric Vogels" <eric.vogels@xxxxxxxxx>]

Hi Stefan.

I'm not a specialist but I did the same asyou did (import) and had to overcome some problems as well. If you send me the model I'll take a look.

eric.vogels@xxxxxxxxx

Eric.

----- Original Message -----

From: stefannilsson2003 <stefan.a.nilsson@xxxxxxxxx>

To: femm@xxxxxxxxxxxxxxx

Sent: Thursday, December 12, 2002 5:13 PM

Subject: [femm] Call to triangle unsucessful after import of DXF

Hello,
David helped me to fix femm 3.2 so that I can import DXF from Autocad
R14. But when I try to create mesh I get the message:Call to triangle
unsucessful. What is the problem?
My model consists of permanetmagnets placed on a steel plate with R
455 mm. It's for a magnet drum.

Help appreciated. I can send model if needed.

Regards
Stefan Nilsson



Your useof Yahoo! Groups is subject to the Yahoo! Terms of Service.