Re: [femm] Triangle call unsuccessful

[Jiri Vecerka <vecerkaj@xxxxxxxxx>]

Dave wrote in past, that there is one reason for "mesh
is unsuccesful". It hapens when the angle of two lines
is too small (sharp angle). I suggest to look for that
and try to eliminate it.

Jiri Vecerka

--- "irishmist_ <djtim@xxxxxxxxxxxxxxxx>"
<djtim@xxxxxxxxxxxxxxxx> wrote:
> David,
> 
> I was having problems meshing an assembly created
> from a DXF import. 
> I have found another situation (unexpected) where
> Triangle will not 
> mesh the geometry. If the tolerance value for the
> DXF import is made 
> too small the resulting geometry will not mesh. (At
> least in my case)
> 
> My particular case is a PM motor of unusual
> construction. (Very high 
> pole count and slots) There are many arc segments
> and I am making an 
> assumption that this is related to the problem. If
> I left the 
> tolerance at the default the problem meshed just
> fine.
> 
> BTW thanks for making this software available.
> 
> Dan
> 
> 
> 
> 


__________________________________________________
Do you Yahoo!?
Yahoo! Mail Plus - Powerful. Affordable. Sign up now.
http://mailplus.yahoo.com