Re: Rif: [femm] Problem with triangle on femm3.3

[Tsarafidy RAMINOSOA <tsarafidy@xxxxxxxx>]

Cool,

 

Thanks a lot ! It works well now.

Yes, it's better to let triangle choose automatically the mesh size rather than giving non realistic value.

Thanks for giving me an idea of the different blocks ' mesh size that I should use.

 

Tsarafidy.

giovanni.bortolan@xxxxxxxxxxxxx wrote:

> Try the attached file.
> You where right thin angles were the problem.
> I have removed al couple of layers at each side of the rotor and changed
> air gap's minimum segment to 1deg. I also changed many blocks'  sizes.
>
> (See attached file: sinc_reluc.fem)
> _______________________________
> ing. G.Bortolan
>
> Sincro srl
> via Tezze, 3 loc. Cereda
> 36073 Cornedo Vicentino (VI)
> ITALY
> Tel: (++39) 0445 450 500
> Fax: (++39) 0445 446 190
> e-mail: Giovanni.Bortolan@xxxxxxxxxxxxx
>                tecnico.sincro@xxxxxxxxxxxxx
> http://www.sogagroup.com
>
> REA 194515/VI
> Reg. Imp. 20968/VI 116
> P.IVA
> 01925820241
>
>
>
>
>
>                                                                                                                                              
>                       Tsarafidy                                                                                                               
>                      
> RAMINOSOA                Per:     femm@xxxxxxxxxxxxxxx                                                                  
>                       <tsarafidy@yahoo        
> Cc:                                                                                            
>                       .fr>                     Oggetto: [femm] Problem with triangle on
> femm3.3                                              
>                                                                                                                                               
>                       25/09/2003
> 12:21                                                                                                        
>                       Per
> favore,                                                                                                             
>                       rispondere
> a                                                                                                            
>                      
> femm                                                                                                                   
>                                                                                                                                              
>                                                                                                                                               
>
>
>
>
> Hi all,
>
> I attached a model of  axially laminated  synchronous  reluctance machine.
> I tried to run it
> on femm3.3 but triangle always crashes. I think the cause
> is the presence of very thin angles at the rotor side laminations.
>
> Do anyone already had this kind of problem? How did he proceed to solve it
> ?
>
> If this was already pointed out in this forum, it would be kind to post me
> the messages references.
>
> Any other comment will be welcome.
>
> Thanks in advance,
> Regards,
>
> Tsarafidy
>
>
>
>
>
>
>
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 
>
>
> > ATTACHMENT part 2 application/octet-stream name=sinc_reluc.fem

---

Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en français !
Testez le nouveau Yahoo! Mail