This could be a "bad DXF" import example--there are a bunch of nearly coincident points in the geometry that make sliver-thin regions with no material definition. The "easy" cure is to specify a bigger number for the tolerance in the DXF import, so that these nearly coincident points stand a better chance of getting consolidated. Anyhow, I put a modified version that I manually checked (run triangle and look for regions with a super-fine mesh to identify problem areas) at:Well, I finally got my first design input into femm (thanks to a lot of help from Dave) and when I try to run the solver, I get the message that "material properties have not been defined for all regions." I tried many changes but I always get the same message. The downloaded file is "FRT_OLD.fem." It is the magnetics for a simple voice coil motor. Can someone please help.
Thanks
Dave. -- David Meeker email: dmeeker@xxxxxxxx www: http://femm.berlios.de/dmeeker